Request a Quote
Request a Quote Call (123) 456-7890

Projects

Fabrication projects, built under one roof.

These are fabrication projects photographed in our own shop in Hazard, Kentucky. Every job runs the same route under one roof: scanned, modeled, fabricated, finished and assembled. Tube chassis work, sheet metal, powder coating and complete assemblies. Most of the fabrication projects below started at 3D scanning or scan to CAD modeling, went through CNC tube bending or sheet metal cutting and forming, and left after powder coating and assembly. To talk about work of your own, request a quote.

CNC plasma table cutting a sheet, one of the fabrication projects in the shop
Plasma notcher cutting a tube, sparks off the cut
Tube chassis tacked together on the welding table
A freshly coated frame hanging on the line
Close-up of a welded joint where two tubes meet
CNC tube bender on the shop floor
A 3D scan of a tube frame on screen
A chassis in the powder coating booth
CNC cut sheet metal panel
Frame finished in a yellow powder coat
Race chassis finished in purple, on stands
Close-up of a green powder coated part
Wheel hubs hanging on the coating rack
Large ring finished in a gold coat
Bent tube beside the bender
Scan data of a frame in the scanning software
Sheet metal panels cut and laid out
Chassis hanging in the coating booth
Engraved disc finished in a textured coat
Tube frame finished in blue
Raw tube chassis in the shop
Sheet metal flat patterns nested in CAD
A run of CNC cut and coated plaques
Bare chassis on the build table
Powder coated steel enclosure
Chassis finished in satin black
Parts finished in red on the rack
Sheet metal box in a translucent blue coat
Chassis being coated in blue in the booth
Close-up of a red metallic powder coat
Close-up of a bronze metallic coat on tube
Tube chassis before finishing
Steel staircase fabricated and installed
The tube bender set up for a run
Bent tubes racked and ready
Steel railings on the rack after coating
CNC cut foam insert for a tool drawer
Cage modeled over the scan of a vehicle
The CNC tube bender mid-bend
A stack of bent tube hoops

New fabrication projects are posted as they leave the shop on the Infinity Fabrication Instagram. To talk about work of your own, request a quote.